Let's talk about bio load.

[StirCrazy]

I think the best way is by food usage, more food the heavier the bioload, but this is complicated by natural occurring food in the tank, like algae that your tangs might eat and so on.

In the end though the only way to tell if your skimmer is big enough is to see if it is removing what it is supposed to by water quality tests. That's why traditionally we have always doubled the size of skimmer that we thought we needed.

Steve

[Proteus]

The problem with doubling up your skimmer size is the removal of beneficial organism. This has been shown in tanks that use zeo or like methods.

[reefwars]

Originally Posted by Proteus

The problem with doubling up your skimmer size is the removal of beneficial organism. This has been shown in tanks that use zeo or like methods.

what organisms are we removing exactly compared to their reproduction rate? are we talking bacteria?

ratings on skimmers vary so do we go by pump specs or by manufacture recommendations, and whats considered a healthy population to begin with and does age of tank play a factor?

im sure skimming removes lots of things including some beneficial bacteria , metals , phosphates and organics etc. alot of these id rather pull out then save , the amount of beneficial bacteria ratio to the reproduction rates it would take a long time to see an effect or complete wipe out, things added to the tank are going to replenish some of these organisms over time as well as the food sources and carbon we add, and new bacterias are always willing to take the role of old ones.

so overall ive always doubled my skimmer , i also carbon dose and rely on my skimmers performance to make it as effcient as it can be since i dont run filter socks or any other way of removing it.

ive often tied new systems into mine so its nice to have a skimmer that can handle a larger water volume and ive also been known to upgrade.
over the years ive had more issues of skimmers not performing rather then performing to well

[Proteus]

I do agree with you. Just stating based on threads on zeovit forum. It's always been suggested to turn off skimmer while dosing and for few hours after. Also zeo claims that using needle wheel skimmer are to efficient. Pulling out the dosed bacteria. I do run a skimmer that's more than 2x the capacity of my tank, but only run it 16 hours a day.

[reefwars]

yes there is , and which is one of the reasons i always dose down stream from the skimmer.

[Dearth]

Another consideration is when setting up a new tank it skims a ton and as the tank matures the amount that is skimmed becomes less and less and that tends to throw a lot of reefers for a loop this can also be said for putting a new skimmer in an established tank

But in the grand scheme of things I honestly don't think there is an accurate way to measure bio load it just comes down to user preference and past experience IMO

[sphelps]

Over-skimming has nothing to do with removing beneficial bacteria, while such bacteria exists in the water column the amount of it compared to what attaches to surfaces in basically zero. Skimming removes bacteria about as effectively as water changes. Over skimming removes desirable elements such as potassium which can effect coral health. This can be avoided even with grossly over-sized skimmers by dry skimming rather than wet skimming and dosing to compensate.

In terms of zeovit the system is based on strong skimming, I remember previous versions of the guide actually stated you couldn't use a skimmer that was too large however that probably resulting in some using ridiculously over-sized skimmers meaning elements where depleted faster than they could be added. Thus the added note stating not too use a skimmer "too oversized" but you should still use an "over-sized skimmer". Also nothing official from zeovit suggests shutting a skimmer off during dosing, only to dose downstream of the skimmer in order to give the bacteria a chance to populate within the aquarium (same for the reactor mull).

Originally Posted by ZeoGuide

As mentioned earlier, the basis of this method relies on export of harmful substances through skimming. Continuous use and frequent cleaning should be conducted in order to keep the skimmer performing at its maximum level. The results are better when the skimmer is adjusted in order not to produce too much concentrated skimmate (wet skimming). We would like to point out that it is our thought that needle wheels may precipitate certain elements and destroy plankton. These elements, e.g. such as potassium, will need to be re-added to the system. Do not use a skimmer that is too oversized or employ wet skimming if you use a needle wheel skimmer. We recommend the use of venturi type skimmers.

[neoh]

I plan the tank based on swimming room, and I think that has a lot to do with the bioload. The detritus needs to be extracted. The more fish you have laying waste, the more problems you could have.

If you were locked in a small room with a lot of people, that place is going to stink and cause you problems. Locked in a large room with a couple people, you're going to have a better time and waste management won't be an issue. If you are locked in a big room with a lot of people, but have a better waste removal solution, you will be a lot happier and only worry about that one dude who keeps eye balling your girl, as opposed to the carpets festering, and causing an ebola outbreak.

Double the skimmer for the tank size (400g on a 200g system) - carbon, gfo, waterchanges, rodi, and only feed the good stuff once a week (mysis, blood worms, etc.), flake once a day and nori once every other day.

I think as long as the system has good turn over, with proper flow to allow small particles and detritus to be caught up into the sump, then the rest is maintenance.

I had an understocked tank and fed three times a day, I had algae and high nutrients with an underpowered skimmer. So now I have an overstocked tank, feed less and skim more, and have no algae, no problems and perfect parameters. I also stopped dosing the unecessaries like reef roids, and other filter feeding material and now maintain better water quality.

[pinkreef]

Did you get your new skimmer Brad? what are you getting if not
Barb

[Aquattro]

Originally Posted by pinkreef

Did you get your new skimmer Brad? what are you getting if not
Barb

I have pumps coming in this week for the various bubble kings, I'll play with those for a while and see what I like. I might run dual BK 160s, maybe a 200. I have an Omega 150 and a Super Reef Octopus here to test. So not sure yet what I'll end up with.