|
|
|
||||||||
| Portal | PhotoPost Gallery | Register | Blogs | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
04-11-2014, 09:27 PM
|
||||
|
||||
pump side 3 pin connector with the dimple up is 24vdc right, gnd (-), left, 0-5v signal on bottom.
you should be able to test pump with low voltage between 0 and 5v on the bottom pin. 24v + is on right pin. common ground on the left pin for both. This pump is same as the wp pump and has same pin standard...at least mine do. 
|
|
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
