RO water, where do you get yours?

[Drfu]

Originally Posted by mike31154

Installation isn't that difficult, but if you're not comfortable with a little DIY plumbing, yes, it may be an idea to get someone with experience to help you out.

With regard to hookup, there's just about any fitting/adapter imaginable available to hook one of these up almost anywhere. Definitely need a drain or very large container for the waste water. Most of these units produce 4 gallons of waste water for every gallon of pure water, so your 8 gallon bucket isn't going to cut it if you're planning on making more than 2 gallons of RO water. I use a 55 gallon plastic drum to collect the waste water, which I use around the house & in the garden in the summer.

Mine is plumbed into the cold water line that feeds my washing machine in the basement. I did the plumbing myself. Added a t-fitting, quarter turn shut off valve and slip on JG type adapters to get the size down to the 1/4 inch tubing that the RODI unit uses.



The white drum laying on its side in this photo is what I use to collect waste water.



Here's a link to Buckeye Hydro showing the many adapters available to plumb into a feed line for RODI system. Their FAQ page is a good place fomoinfo about what's required to properly run a system.

http://www.buckeyehydro.com/feedwater-fittings/

Never thought of my laundry room, has a drain for waste water, has the standard garden hose output for incoming water so all i would have to make room for is a storage unit.

How fast thes the aquasafe aquarium 2 output water and how hard. Im gonna guess since it says on their site its 100gpd, its spec is 1:1 ratio to make sound beter so i should expect 25gpd @ 4:1, which would be just over a gph? Also could it pump water 8' from my room right to my fw tank, does it have enough pressure?