![]() |
|
#1
|
|||||
|
|||||
![]() We run full zeo on our 600g SPS system and cannot keep PO4 in check without GFO.
We only have 12 fish but we do also have 400 troches snails and 200 peppermint shrimps in there.
__________________
Canada Corals http://www.canadacorals.com https://www.facebook.com/CanadaCorals https://twitter.com/CanadaCorals ![]() |
#2
|
|||||
|
|||||
![]() That makes me question zeo at all then
|
#3
|
|||||
|
|||||
![]() I started zeo day 1 and have never had PO4, so not sure if it's better at keeping it low, or lowering it if it's present.
__________________
Brad |
#4
|
|||||
|
|||||
![]() Quote:
What a difference ever since. Unfortunately GFO is not really an economical alternative to zeovit! At least not on my tank.
__________________
-- Tony My next hobby will be flooding my basement while repeatedly banging my head against a brick wall and tearing up $100 bills. Whee! |
#5
|
|||||
|
|||||
![]() if you're targeting a ratio why not lower the PO4 with gfo rather than raising the nitrates? i'm not zeoliterate and quite possibly a moron.
</0.02> |
#6
|
|||||
|
|||||
![]() You're correct on this. I did just that! Less stress on the corals too! Zeo diehards believe that saying " no pain no gain".
__________________
ATI 48" 3x75W LED with 8x54W T5, 2xTunze 6105, 2 x Maxspect Gyre XF150, Bubble King Mini 200 ( soon to be replaced by a Bubble King SM 200), Eheim 1262, Via Aqua 300 watt Titanium heater, JBJ ATO, Apex Controller |
#7
|
|||||
|
|||||
![]() Sells peppermint shrimp, buys a used car...
|
#8
|
|||||
|
|||||
![]() Going to buy a new test kit today. Stopped buy Waynes and tested his water against his test kit lol. Red sea may be out to lunch as according to his test his water was. 0.05 and my test kit showed it At 0.64
|
#9
|
|||||
|
|||||
![]() Quote:
![]()
__________________
ATI 48" 3x75W LED with 8x54W T5, 2xTunze 6105, 2 x Maxspect Gyre XF150, Bubble King Mini 200 ( soon to be replaced by a Bubble King SM 200), Eheim 1262, Via Aqua 300 watt Titanium heater, JBJ ATO, Apex Controller |
#10
|
|||||
|
|||||
![]() I use the Red Sea kit for mg. and it seems accurate.
Maybe it's just the po4 one that's bad |
![]() |
Thread Tools | |
Display Modes | |
|
|