![]() |
|
Portal | PhotoPost Gallery | Register | Blogs | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
![]() |
|
Thread Tools | Display Modes |
|
#1
|
|||||
|
|||||
![]() Epoxy is known to cause that, have you used any?
![]() |
#2
|
||||
|
||||
![]() yes did epoxy sum rock together
will it go away after awile??? |
#3
|
|||||
|
|||||
![]() i had to turn off skimmer and do a water change
then start it up again may be necessary to repeat soon you will get so its running properly again |
#4
|
|||||
|
|||||
![]() ya that may be the issue turn the skimmer level down and let it run its course.
__________________
180 starfire front, LPS, millipora Doesn't matter how much you have been reading until you take the plunge. You don't know as much as you think. |
#5
|
||||
|
||||
![]() thanks for the help
going to do a 5 gal water change today |
#6
|
|||||
|
|||||
![]() You can lower the water level a bit too and that may help. The blue water line on the DOC skimmers is the maximum level, not the suggested level. When my 9016 was in my tank I usually had issues when the water was at the line vs. a little below it.
|
![]() |
Thread Tools | |
Display Modes | |
|
|