![]() |
#91
|
|||||
|
|||||
![]() Tony, what's the rush?
![]() Thanks kien, it almost took me a full 20 minutes to design that. ![]() The spread does look good on those ATI's. - and yes, 6 Mitras may have not been enough - another reason I went for the ATI's
__________________
Mitch |
#92
|
|||||
|
|||||
![]() In the sump I'm replacing my electric heaters with a coil of PEX that will be heated with a hot water recirc loop controlled with the Profilux.
There are plastic PEX fittings available for corrosive environments.
__________________
Mitch |
#93
|
|||||
|
|||||
![]() Interesting ... where would the water for the loop get heated?
__________________
-- Tony My next hobby will be flooding my basement while repeatedly banging my head against a brick wall and tearing up $100 bills. Whee! |
#94
|
|||||
|
|||||
![]() I tap into the hot water tank and run domestic water through it.
A 25W recirculation pump pulls hot water in a loop from the hot water outlet pipe and returns it to the cold water inlet pipe on the hot water tank. So the heat comes from the normal operation of the hot water tank.
__________________
Mitch |
#95
|
|||||
|
|||||
![]() What material are the pex rings made of ???
__________________
Mike 36 Gallon Saltwater http://www.canreef.com/vbulletin/showthread.php?t=72283 90 Gallon Slow Build http://www.canreef.com/vbulletin/showthread.php?t=82824 |
#96
|
|||||
|
|||||
![]() Stainless steel
__________________
Mitch |
#97
|
|||||
|
|||||
![]() I've learned that there's a different system available that uses plastic crimp rings - Propex.
I'm looking into that to see where it's available.
__________________
Mitch |
#98
|
|||||
|
|||||
![]() Other than the cost of buying a conventional heater (if you didn't already have one) and the (remote) possibility of the heater breaking, what's the advantage to doing it this way ?
Seems a bit of "Six of one, half dozen of the other"
__________________
-Mark 29 Gal Bowfront w/24" LED Lights. DIY HOB Sump (5.4 Gal) MP40. Orange Spotted Watchman Goby, 2 Clownfish and a few hermits. |
#99
|
|||||
|
|||||
![]() The primary benefit is using less electricity.
For a water volume of around 700 gallons, I would need probably 600 - 800 watts of electric heat. I've read articles that suggest heaters should be replaced every couple of years. We also have a hot water solar system that sometimes produces excess heat, so it makes sense to dump the excess heat somewhere useful. And... -Saves space on the Profilux power bar -Don't need to run as many electrical circuits It may not make sense for smaller tanks, but I think it's a great idea for larger ones.
__________________
Mitch |
#100
|
|||||
|
|||||
![]() Mitch,
Look into these fittings. All plastic, very reliable. The system is called quick and easy by uponor. By far one of the best plastic systems. If you need any info lmk. Thanks, Bob
__________________
There's plenty of room for all God's creatures. Right next to the mashed potatoes. |
![]() |
Thread Tools | |
Display Modes | |
|
|