Got a wee bit done this morning over my coffee. Drilled one of the heatsinks to within about 1/8" of the back of the 3-up stars since they'll be on the longest and probably run the hottest. Then a bit of thermal epoxy dabbed in the hole and plunked a DS 18B20 sensor down in there. I need to find a way to block off this vane a bit to try and make it not so affected by the fan, thinking of just cutting a tight fitting piece of foam or something and gluing it down in there between the sensor and fan.
I'll try and wire a bit of it tomorrow morning.
06-07-2013, 12:38 AM
Threaded Mode
