SWC 250 S2 Skimmer mods

[FishyFishy!]

Originally Posted by lastlight

I would imagine anywhere on the outlet is fine. I'd do it as you have demonstrated. The operation of the gate valve in that location would do exactly the same thing as twisting to pipe (letting more or less water out).

Just leave your pipe in the fully open position and let the valve do the restricting. No need to even glue the valve in place so you can try this now.

Yeah thats what I thought. I suppose it's just plumbing, so if it dosn't work, I can always make it stock again.

I will forget about cutting the wedge pipe flat and just keep it in the open position as you said, so that I can use it again if I mess this up lol.

[FishyFishy!]

I also replaced the pump air intake (to the silencer) tubes. They were super flimsy and were one of the major startup and failure issues of these sicce pumps. They kinked (as you can even see in the top picture, tube on the left is kinked) and caused a whole bunch of issues. So I replaced them with thicker vinyl tubing to prevent that kinking.