FS/FT. SUNCORAL AND FUNGIA (EDM)

[Reef Pilot]

Originally Posted by reefwars

depends on the type if its branching i just use frag cutters if its the matting type then i use a diamond blade on a angle grinder cutting from the bottom i make a slice from east to west about 1/2" or so deep depending on how thick it is.

i then use a flat top screwdriver and place it into the grove i cut, i then twist the flattop leaving me with 2 halves, if i need to make multiple frags then i make a grid of lines with my grinder then use the screwdriver to break multiple pieces.

the idea of cutting from the bottom to the top is to not damage the flesh with the hot blade so basically like scoring a line but its deep and breaking it.

any attached flesh can be cut cleanly with a new razorblade.

i take the same approach with zoos as well

Thanks. Sounds like the skeleton is not too hard/thick then if you can use a cutter. I've had a to use a chisel and hammer on my bubble coral to break it apart. This should be a lot easier. And sawing a groove on the bottom makes sense, too, if necessary.