Canreef Aquatics Bulletin Board  

Go Back   Canreef Aquatics Bulletin Board > General > Reef

Reply
 
Thread Tools Display Modes
  #1  
Old 01-08-2013, 10:20 PM
gregzz4's Avatar
gregzz4 gregzz4 is offline
On Hiatus
 
Join Date: Oct 2011
Location: Burnaby, B.C.
Posts: 4,890
gregzz4 will become famous soon enough
Default

Really sorry to be reading about all your losses lately Pat
Since your Mandy is still swimming, I'm probably wrong but ...

If I recall correctly, this started right after you set up your dosers, yes ?
Have you checked into possible contamination from your dosing products and/or equipment ?
Also, have you tested for copper ?
And a long shot, but is your RO still removing all chlorine (or chloramines if your municipality uses it ) ?

Hope you figure out the cause
Reply With Quote
  #2  
Old 01-08-2013, 10:25 PM
Proteus's Avatar
Proteus Proteus is offline
Member
 
Join Date: Apr 2011
Location: Devon
Posts: 2,784
Proteus is on a distinguished road
Default

Last I recall pat uses city water. I to did for a while and in reality the water this time if year is probably when it's at it's cleanest
Reply With Quote
  #3  
Old 01-08-2013, 10:47 PM
paddyob's Avatar
paddyob paddyob is offline
Member
 
Join Date: Oct 2008
Location: Edmonton
Posts: 2,481
paddyob is on a distinguished road
Default

Quote:
Originally Posted by gregzz4 View Post
Really sorry to be reading about all your losses lately Pat
Since your Mandy is still swimming, I'm probably wrong but ...

If I recall correctly, this started right after you set up your dosers, yes ?
Have you checked into possible contamination from your dosing products and/or equipment ?
Also, have you tested for copper ?
And a long shot, but is your RO still removing all chlorine (or chloramines if your municipality uses it ) ?

Hope you figure out the cause

Yes. Right after I added the doser and switched from seachem builder to bulk kh. I my levels are ok now so I think the bulk chemical is bad.


No ro. Never have. 6 years without a problem.

Copper I tested at one point but came up negative. However I just added chemipure elite to absorb any possible copper that maybe I was unable to test.

As for equipment I plan to check it all after I remove the last couple softies and find my neon.

I am going to remove the rocks to a separate tank. Then cure them in the dark. Remove all the sand and clean it. As well as clean the sump and check for rusty parts that may be leaching.

Ugh.

I'll start a new thread for the "rebuild" or maybe just keep the current going and it will be full record.
__________________


My 70 Gallon build:

http://www.canreef.com/vbulletin/showthread.php?t=66478


My Mandarin Paradise:

http://www.canreef.com/vbulletin/showthread.php?t=72762



I wonder... does anyone care enough to read signatures if you make them really small? I would not. I would probably moan and complain, read three words and swear once or twice. But since you made it this far, please rate my builds.
Reply With Quote
  #4  
Old 01-09-2013, 02:44 AM
daniella3d's Avatar
daniella3d daniella3d is offline
Member
 
Join Date: Jun 2010
Location: longueuil, quebec
Posts: 1,979
daniella3d is on a distinguished road
Default

wow, I think that's the problem. There is something in your water that is killing the bristle worms and it is probably not coming from the dosing or from the salt.

6 years without problem and then this? When I had my discus, I used the RO water and some friend used city water until one day there was a contamination in the water supply and most of his fish died. It can happen.

When my tank was contaminated by Kent carbon with copper, the level was beyond what a normal test can register, yet many of my coral died, a lot of pods too.

I would use polyfilter as well.


Quote:
Originally Posted by paddyob View Post


No ro. Never have. 6 years without a problem.

Copper I tested at one point but came up negative. However I just added chemipure elite to absorb any possible copper that maybe I was unable to test.

As for equipment I plan to check it all after I remove the last couple softies and find my neon.

I am going to remove the rocks to a separate tank. Then cure them in the dark. Remove all the sand and clean it. As well as clean the sump and check for rusty parts that may be leaching.

Ugh.

I'll start a new thread for the "rebuild" or maybe just keep the current going and it will be full record.
__________________
_________________________
More fish die from human stupidity than any other disease...
Reply With Quote
  #5  
Old 01-10-2013, 04:18 AM
paddyob's Avatar
paddyob paddyob is offline
Member
 
Join Date: Oct 2008
Location: Edmonton
Posts: 2,481
paddyob is on a distinguished road
Default

I'm going to continue this in my build thread. I have uploaded a few pics.

The last of the livestock that's alive has been moved to the 20g with the mandarin.


Here is the link direct to the page...

http://www.canreef.com/vbulletin/sho...747#post780747
__________________


My 70 Gallon build:

http://www.canreef.com/vbulletin/showthread.php?t=66478


My Mandarin Paradise:

http://www.canreef.com/vbulletin/showthread.php?t=72762



I wonder... does anyone care enough to read signatures if you make them really small? I would not. I would probably moan and complain, read three words and swear once or twice. But since you made it this far, please rate my builds.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT. The time now is 01:18 AM.


Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.