![]() |
|
Portal | PhotoPost Gallery | Register | Blogs | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
![]() |
|
Thread Tools | Display Modes |
|
#1
|
|||||
|
|||||
![]() Best: bare bottom (JMO)
2nd best: new sand Put the old sand back in and you'll likely battle PO4 for a while. |
#2
|
|||||
|
|||||
![]() I've done this a couple times now & the best way is:
Drain as much water as possible while relocating coral first. Remove rock as it is getting close to the water a piece at a time leaving any pieces that are in the sand until all coral & fish are out. Then go in for the fish, fill the temp home first so it's ready to go & put a heater in it to keep it warm as well as the coral bin & rock. Once everything is out remove as much of the remaining water as possible, then last of the rock. Scoop out the sand into a bucket & using a lg fine mesh fish net rinse 2 - 3 cups of sand at a time under the tap until water is clean, dump into a different bucket obviously ( you know that already ) Once it's all rinsed & new tank is in place reverse the order & rebuild. That being said if you need a few extra heater I have a bunch you can borrow.
__________________
Feed the bear goodies, make a new friend, don't feed the bear............... 8' - 165gal Reef DIY LED's Build 2012 Nano Contest Winner Febuary 2013 POTM Winner 300 gal + 60 gal Complete DIY Build |
#3
|
|||||
|
|||||
![]() Quote:
Personally though I find it such a pain to rinse all the old sand out, much easier and safer to just buy new sand.
__________________
One more fish should be ok?, right!!! ![]() |
#4
|
|||||
|
|||||
![]() Yes it is a PITA but cost wise it's more reasonable.
__________________
Feed the bear goodies, make a new friend, don't feed the bear............... 8' - 165gal Reef DIY LED's Build 2012 Nano Contest Winner Febuary 2013 POTM Winner 300 gal + 60 gal Complete DIY Build |
#5
|
|||||
|
|||||
![]() I too have done this several times. Just rinse ur old sand and keep rinsing. I use RO water but I have a huge reservoir. Keep 2-3 cups of your old sand and don't rinse that and just mix it in with the rinsed sand. Don't know about the others but I do the same with brand new sand anyways. But if one can afford to run a SW tank than sand really isnt that expensive
|
#6
|
|||||
|
|||||
![]() Thanks for the help
Spent the day moving everything and the new tank is up and kind of running. Old sandbed is still in the old tank, I may rinse it really good tomorrow but we'll see how ambitious I am. I may just buy new stuff, we'll see how tomorrow morning goes! Back into a big(ish) tank - 75 gallons now! Feels good ![]() |
#7
|
|||||
|
|||||
![]() Did you use the same stand the old tank was on?
__________________
Feed the bear goodies, make a new friend, don't feed the bear............... 8' - 165gal Reef DIY LED's Build 2012 Nano Contest Winner Febuary 2013 POTM Winner 300 gal + 60 gal Complete DIY Build |
![]() |
Thread Tools | |
Display Modes | |
|
|