GHL Mitra Owners club

[Aqua-Digital]

Just want to add an important point here

You wont see any disco ball effect with the Mitras. The reason for this is in the reflectors (not lenses) The reflectors converge the LED output to a uniform spread (convergence) eliminating any hot spot or higher intensity spot.

98% of the LED output is reflected back into the water matching that of a T5 reflector.

The Mitras was developed along with a leading University in Germany over two years, so there are a number of cutting edge technologies employed.

This spectrum analysis against ATi 54W T5 is quite impressive



The light blue thin line is the ATi

[subman]

I was up late last night wrapping presents (way later than normal lol) I noticed my Mitras were on all night even though the display was zeros across the board. I'm guessing it is just moonlighting.
Where is the setting to turn this off or at least make it much dimmer?

[Aqua-Digital]

In the software, you need to set a zero point time for example

11pm 0%
6am 0%
7am 10%

then between 11pm and 6am all will be off

[subman]

I'm sure I did that, I'll have to double check.
Michael what's the latest firmware?

[Aqua-Digital]

1.07 is the latest

make sure the channels are all at zero too

[subman]

got it I had all the channels at zero but had to set 2 new points on the light composer and now its black out from midnight to 4am

Now that I have used it a bit more the software is great. The first time I set things up I didn't use the light composer, I just set up each individual channel. The light composer is pretty slick

[sphelps]

Originally Posted by subman

Now that I have used it a bit more the software is great. The first time I set things up I didn't use the light composer, I just set up each individual channel. The light composer is pretty slick

I did the same thing and quickly got frustrated until I figured out the light composer does it all for you, that's why I mentioned it earlier. Without it you'd spend a lifetime setting up all the channels properly.