Cannot stop bulkhead leaking!

[wickedfrags]

use a threaded male adapter on the inside of the bulkhead to assist in removing the outside nut....should help stop the spinning....assuming your bulkhead is double threaded...

i would try the rubber gasket on the inside if only one came with the bulkhead fitting

Originally Posted by duncangweller

I believe it is a 1 3/4 hole. When I had the tank set up in my old place there was a minor leak around the bulkhead which stopped after a few days. Since I have moved o can't get the thing to stop leaking.

Also, now that I have tried a gasket on both sides I can't get the bloody nut off the outside.......aaaaaaarrrggggghhhhhh!

Sent from my Nexus 7 using Tapatalk 2

[sphelps]

You'll save yourself a lot of grief by using a Sch80 bulkhead rather than the cheap thin ones you get at most LFSs. They have courser threads and thicker gaskets and aren't nearly as finicky as the ones you're using. Only down side is you'll have to use a smaller size as they require larger holes but you can use bushings/reducers before and after to maintain existing pipe size so the effects are pretty minimal.