3D Printing Aquarium Parts - Canreef Aquatics Bulletin Board

		Canreef Aquatics Bulletin Board > General > DIY
3D Printing Aquarium Parts

#27

10-20-2012, 10:33 PM

imisky

Member

Join Date: May 2006

Location: Langley, BC

Posts: 243

so here is a 100 micron print shot with a macro at 1:1 and f2.8. This thing is only..3cm tall, but took an hour to print

Cute Octopus by Tinkerine Studio, on Flickr

and with it beside a 9.2cm bigger version that didnt take that much longer at 200 microns to print

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT. The time now is 08:18 PM.