Help programming RKE myReef float switch

[Casey8]

I put my probe in a filter sock, so it gets the water temperature from your DT.

[gregzz4]

Originally Posted by Casey8

I put my probe in a filter sock, so it gets the water temperature from your DT.

Yup, looks like that's what I'll have to do
I was hoping to probe the water before all the plumbing, but I guess it doesn't make that much difference, does it ?

[Casey8]

You can go to this forum to get help or email them directly, you get an answer in less than 24 hrs.

http://www.forum.digitalaquatics.com...?f=26&start=25

[gregzz4]

Thanks Casey
If I have to, I will contact DA
I've read through all their forum info, but some of it is still useless.
This case is a prime example where reefme showed me something not clarified on the DA site

[Casey8]

Originally Posted by gregzz4

Thanks Casey
If I have to, I will contact DA
I've read through all their forum info, but some of it is still useless.
This case is a prime example where reefme showed me something not clarified on the DA site

That was why I just email them and get an answer promptly and accurately what I want because I don't have patience like you

[gregzz4]

I now have the Temp probe in the sump's heater chamber
This is where I will put the pH probe and the Ranco probe as well

I can sleep with this setup, but I will definately be doing some research or DA e-mails to sort this, and other issues, out

[Cal_stir]

I set up my heater as a controller, sensor port is SL1-temp, direction is below, setpoint is 78, hysterisis is .01.
You should use 2 switches to control your pump, 1 that turns it on and 1 that turns it off and set the height @ 1/4" apart, that will prevent the toggle effect.