New Custom Mounting Brackes for Aqua Illuminations LEDs and EcoTech Radion

[Kryos]

I've done a mockup with measurements:


the three small holes are 1/4" in diameter and the larger hole for the slit is 1/2" in diameter as per the holes on my light fixture.

The part circled in red measures to be 1/8" thick, do you think there will be any problems holding up the lights with it being that thin?

Thanks,

[martinmcnally]

Originally Posted by Kryos

I've done a mockup with measurements:


the three small holes are 1/4" in diameter and the larger hole for the slit is 1/2" in diameter as per the holes on my light fixture.

The part circled in red measures to be 1/8" thick, do you think there will be any problems holding up the lights with it being that thin?

Thanks,

Hi Kryos, there should not be a problem with that. The 1/8 will be fine as that is not really a stress point in it and it is really sturdy steel anyways. Just quote this thread with your order and I will make sure to pass the graphic on.