Replacement pump for BRS Reactors

[shootingstar]

Thanks for the suggestion, yes they would probably still be under warranty but they have been nothing but grief from the start so I would rather replace them at this point.

Not quite sure how I would set them up to run off one pump as they are run through my apex and operate on different cycles.

[eli@fijireefrock.com]

If you have a decent main pump,I suggest tapping into it then you don't need to worry about another pump or a higher electrical bill.

[shootingstar]

Thanks Elias,

Currently running a Dart external (3600 gph) which would be way overkill for the reactors to be able to handle I would think.

Right now the reactors run off small submersable pumps in the first chamber of the sump.

The Dart external feeds the tank, T's off to an attached frag tank (gravity return to sump) and an adjustable re-direct back into the sump.

I can't imagine I will be able to talk the hubby into re-plumbing the whole system.

Both suggestions are appreciated and once I get home from work will sit and stare at the sump and see if there is a way to make them work.

Cathy

[eli@fijireefrock.com]

You should be fine with tapping a line to your reactor as you pump is large enough and should cause you no problem.just use a valve that I think you have with the reactor,I could take a couple pictures later to show you as I have that setup running.