![]() |
|
Portal | PhotoPost Gallery | Register | Blogs | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
![]() |
|
Thread Tools | Display Modes |
|
#1
|
|||||
|
|||||
![]() a bath in a good coral dip can sometimes help.....frag off a good healthy piece and place it somewhere else in the tank.....cut out all the dead stuff and crazy glue the edge between the living and dead tissue, that can help too.....what are your parameters?.......perhaps spring run-off issues?
__________________
260g mixed reef, 105g sump, water blaster 7000 return, Bubble King SM 300 skimmer, Aqua Controller Jr, 4 radions, 3 Tunze 6055s,1 tunze 6065, 2 Vortech MP40s, Vortech MP20, Tunze ATO, GHL SA2 doser, 2 TLF reactors (1 carbon, 1 rowa). http://www.canreef.com/vbulletin/showthread.php?t=50034 . Tank Video here http://www.vimeo.com/2304609 and here http://www.vimeo.com/16591694 |
#2
|
|||||
|
|||||
![]() I suppose it could be spring run off issue's as I don't have a phos test kit....but my other perams are
trates 0 amonia 0 ph 8.2 sal 1.026 alk 9 mag 1350 cal 400 I change 5 gals of water every week As for trimming back that plate I just can't figure out how I would do that with out putting a saw in the the water.
__________________
90 Gal mixed reef with a custom 40 gal sump, SWC Mini S skimmer, 8X56 Watt fan modded Tek, 2x2LF reactors, mag 12 return, Tunze ATO and a modded Tunze 6100 running on a DIY wave controller My TOTM thread http://www.reefersparadise.com/smf/i...?page=page4263 |
#3
|
|||||
|
|||||
![]() what temp is your tank at? I read an article where they found that RTN was more likely happen in warmer tanks and may remain dormant in cooler tanks. Try lowering your tank to 75 degrees and see if it slows the process down.
|
#4
|
|||||
|
|||||
![]() I have noticed the spring runoff phenom in the past...colonies die off for no reason. You didn't do any moving of rock wok or anything that could of caused a spike in nitrates?
|
#5
|
|||||
|
|||||
![]() Quote:
Nope nothing, in fact I was a way for the weekend when it started......the only thing I could think of was that the Nem stretched up another inch and stung the Pocillipora.
__________________
90 Gal mixed reef with a custom 40 gal sump, SWC Mini S skimmer, 8X56 Watt fan modded Tek, 2x2LF reactors, mag 12 return, Tunze ATO and a modded Tunze 6100 running on a DIY wave controller My TOTM thread http://www.reefersparadise.com/smf/i...?page=page4263 |
#6
|
|||||
|
|||||
![]() Quote:
It's at 78deg right now.....you don't think going down that low would hurt anything?
__________________
90 Gal mixed reef with a custom 40 gal sump, SWC Mini S skimmer, 8X56 Watt fan modded Tek, 2x2LF reactors, mag 12 return, Tunze ATO and a modded Tunze 6100 running on a DIY wave controller My TOTM thread http://www.reefersparadise.com/smf/i...?page=page4263 |
#7
|
|||||
|
|||||
![]() Here's a shot of what I'm dealing with......it has been creeping across my monti for 3 days now and I'm starting to think I'm going to have to snap off some large chunks to try and save as well as yank the Stag off the rock and move it before it's to late.
![]()
__________________
90 Gal mixed reef with a custom 40 gal sump, SWC Mini S skimmer, 8X56 Watt fan modded Tek, 2x2LF reactors, mag 12 return, Tunze ATO and a modded Tunze 6100 running on a DIY wave controller My TOTM thread http://www.reefersparadise.com/smf/i...?page=page4263 |
#8
|
|||||
|
|||||
![]() IME, hack and slash... Remove any and all dead tissue. Dip any remaining healthy frags in an iodine based dip. My tendency is to wait too long...
__________________
400 gal reef. Established April, 2007. 3 Sequence Dart, RM12-4 skimmer, 2 x OM4Ways, Yellow Tang, Maroon Clown (pair), Blonde Naso Tang, Vlamingi Tang, Foxface Rabbit, Unicorn Tang, 2 Pakistani Butterflies and a few coral gobies My Tank: http://www.canreef.com/vbulletin/showthread.php?t=28436 |
#9
|
|||||
|
|||||
![]() Quote:
I went in tonight snapped off the stag and turned it so it wasn't touching the monti....the gave it everything I had to break off either the monti or a large chunk...no go man (it's an inch and a half thick) so instead I broke off a bunch of healthy frags and apoxyed them to the rock work a little to the left of the mother colony. Any tips on how to cut it wile still in the tank?
__________________
90 Gal mixed reef with a custom 40 gal sump, SWC Mini S skimmer, 8X56 Watt fan modded Tek, 2x2LF reactors, mag 12 return, Tunze ATO and a modded Tunze 6100 running on a DIY wave controller My TOTM thread http://www.reefersparadise.com/smf/i...?page=page4263 |
![]() |
Thread Tools | |
Display Modes | |
|
|