Canreef Aquatics Bulletin Board  

Go Back   Canreef Aquatics Bulletin Board > General > Reef

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #18  
Old 05-13-2011, 04:21 AM
asylumdown's Avatar
asylumdown asylumdown is offline
Member
 
Join Date: Jan 2010
Location: Calgary
Posts: 1,806
asylumdown is on a distinguished road
Default

This sounds exactly like what was happening to me when my water chemistry went weird.

a) what alk supplement is he using? is it baking soda from a grocery store, or something prepared specially for reef tanks? I know they're supposed to be essentially the same, but when I used baking soda, my water chemistry went haywire, and the ratios of solution made no sense. I also ended up with pumps failing weekly due to precipitation.

b) is he adding carbonate or bicarbonate as his alk source (carbonate would be if he's 'cooking' his bicarbonate)? With pH levels and dosing volumes both being that high, I suspect he's adding something with a lot of carbonate, which is considerably less soluble and more likely to precipitate out than bicarbonate.

c) It sounds like he's adding so much carbonate/bicarbonate that his levels are never balanced. Is he using an auto-doser? If he's pushing one past the 'limit', addition of the other will instantly react and precipitate out. I think you can get in to a vicious cycle. I bet at one point in the past he overdosed on one additive (likely alk), which caused a precipitation reaction that depressed his levels of calcium. On a test kit, it would have looked like he had low calcium and normal alkalinity. If he's using a doser, he would have then upped the amount of calcium he was adding every day. However, there would still be excess carbonate being added, so the precipitation would continue, and appear to depress his alk levels. So then he upped the amount he dosed alk, which would depress the calcium levels again... so on and so forth, always upping one, seeing a drop in the other, upping it, then seeing a drop on the other side. The end result would still look like he has 'normal' levels in his water, but that's because massive amounts are instantly precipitating out on pumps, etc. If this is the case, he needs to start dialing back on the amounts he's adding in the same way he upped his dosing volumes.

In either case, there's no other answer, he's adding too much. That's the only explanation for the precipitation. The 'normal' levels he's seeing aren't 'normal' at all, they're what's left over after the precipitation of the excess he's added to the system.
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT. The time now is 10:06 PM.


Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.