![]() |
|
Portal | PhotoPost Gallery | Register | Blogs | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
![]() |
|
Thread Tools | Display Modes |
#11
|
|||||
|
|||||
![]() Kent's systems use cheaper parts which I don't like and Vertex doesn't offer enough flexibility in my mind. BWI is probably fine but they only have 100gph membranes available... 75gpd has a higher rejection rate and has been what was recommended to me in the past. So I like the units sold on Bulk Reef Supply. They use john guest fittings, Filmtec membranes and you can opt to build your own system consisting of only the parts that you want.
__________________
"We shall dive down through black abysses... and in that lair of the Deep Ones we shall dwell amidst wonder and glory forever." - H.P. Lovecraft Old 120gal Tank Journal New 225gal Tank Journal May 2010 TOTM The 10th Annual Prince George Reef Tank Tour |
#12
|
|||||
|
|||||
![]() First thing you might want to do is some research on your water source at the new house. Find out where it's coming from, presumably the City of Calgary, go on their web site and check the water reports to give you an idea of what to expect at your tap. Then get a cheap handheld TDS meter and take some readings after you move in. This will help determine what sort of RO system you require. Also find out if your water provider uses chlorine or chloramine to treat the water. This will have an impact on how many carbon stages you need (usually one extra for chloramine).
My 77 evaporates about a gallon a day, when I first started I used tap water treated for chlorine. I couldn't imagine having to go out and by RO water then lug it home for weekly evaporation and scheduled water changes. I purchased a system from BWI and am very pleased with it. It came with two carbon stages, but I recently removed one & replaced with a second poly filter since the extra carbon is not required for chlorine.
__________________
Mike 77g sumpless SW DIY 10 watt multi-chip LED build ![]() |
#13
|
|||||
|
|||||
![]() Quote:
Thanks once again for yours and everybodys input! Any more tips or anything on this topic would be helpful! ![]()
__________________
![]() ![]() |
#14
|
|||||
|
|||||
![]() No problem. Most systems offered for our use are very much the same, but by knowing a little more about your source water you could save yourself one or more stages of filtration. It would help if a few folks from Calgary would provide additional input to help you make a choice. The TDS for folks in Vancouver is so low out of the tap, they could probably run a DI stage only and forego the RO section altogether. My source TDS is in the 210 to 220 range and the 75 gpd RO stage takes that down to 1 or even 0 in the winter with colder water, the DI stage takes care of the residual TDS.
__________________
Mike 77g sumpless SW DIY 10 watt multi-chip LED build ![]() |
#15
|
|||||
|
|||||
![]() Any info from Calgarians?
__________________
![]() ![]() |
#16
|
|||||
|
|||||
![]() My TDS is about 130 in NW Calgary.
I have a 35 gal setup presently and just getting the tank up and running the first month of water changes cost me something like $80 in jugs of water. Before you buy a single jug of water, go and buy an RO/DI system. The longer you wait, the more $ you'll waste on buying water. RO systems aren't that expensive and even a $300 system will pay for itself in a reasonable period (depending, of course, on your tank size / water needs). I also use mine to replace the Culligan service I had so I'm saving even more. Add to that the convenience of not having to lug jugs to the store and it's a no-brainer.
__________________
-Mark 29 Gal Bowfront w/24" LED Lights. DIY HOB Sump (5.4 Gal) MP40. Orange Spotted Watchman Goby, 2 Clownfish and a few hermits. Last edited by DiverDude; 04-16-2011 at 04:59 AM. |
#17
|
|||||
|
|||||
![]() Get an RO unit for sure, from what I have read about most larger cities the water supply really goes to crap in the spring with all the melting run off so the cities dump more chemicals into there systems to make it consumable. I have a whole house RO system & when the wife & I go any where & have a glass of water the taste of it really makes me wish I was at home.
__________________
Feed the bear goodies, make a new friend, don't feed the bear............... 8' - 165gal Reef DIY LED's Build 2012 Nano Contest Winner Febuary 2013 POTM Winner 300 gal + 60 gal Complete DIY Build |
#18
|
|||||
|
|||||
![]() Just wondering for all those in Alberta, where's the best place to buy pre-filters, RO membranes and DI filters?
|
#19
|
||||
|
||||
![]() I got my 3 stage one from Filter Direct. We have it as a stand alone though, there's also no tank with it. But it does the job.
__________________
90 gallon mixed reef, 29 gallon FOWLR, 6 gallon nano |
#20
|
||||
|
||||
![]() I just bought a Buckeye Field Supply 75 gph RO/DI unit. $250 shipped with all the fittings to hook up to the water supply. Some info:
http://www.reefcentral.org/forums/sh....php?t=1280759 I think lugging RO water from the store will get old really fast, especially when you need to do a large water change to solve a problem. I think at least one fish store in Calgary uses conditioned tap water (maybe it was just a rumor). It might be an option though I suspect not many people would recommend it. Are there any tanks of the month from Calgary using tap water? |
![]() |
Thread Tools | |
Display Modes | |
|
|