![]() |
|
Portal | PhotoPost Gallery | Register | Blogs | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
![]() |
|
Thread Tools | Display Modes |
|
#1
|
||||
|
||||
![]() I have eggcrate in the bottom of my tank. I covered it with a couple inches of sand and haven't seen it since.
|
#2
|
|||||
|
|||||
![]() i have eggcrate and i covered it with about 1.5in sand all around
the high flow areas started to show the eggcrate but now that its about 7 months in, i started moving around the sand just enough to cover the eggcrate and its starting to stick better. |
#3
|
||||
|
||||
![]() I've got three tanks with, one without. One with has only about 1" of sand and sometimes the egg crate is exposed by the flow, looks terrible. One has about 3" of sand I've never seen the egg crate in the tank, I like it. One just has the rock sitting in the EC no sand. It doesn't look very good, I thought it would cover over in coraline, but hasn't in 2 years. It is also a pain to syphon detritus out of at water change time. The BB is great for syphoning at water change time, out of the two without sand I like it the best.
A long story short, if you are going BB don't use egg crate, if your going to use sand then use it, IMHO. |
#4
|
|||||
|
|||||
![]() I cut some large diameter ABS pipe into sections to support several large pieces of live rock. Drilled random holes in the sides for circulation. I should have siliconed them on to the bottom glass though, since they've shifted a bit on me while I was messing around rearranging stuff. Next time I start up a tank, I'll likely do the same or just cut semicircular sections as shown in the photo below. By using sections of ABS like this, you have more flexibility as to placement and the entire bottom doesn't have to be covered as when you use eggcrate, allowing for better access and circulation. Another advantage is you can customize the height and profile of the ABS pieces to better suit the shape of a particular rock.
![]()
__________________
Mike 77g sumpless SW DIY 10 watt multi-chip LED build ![]() |
#5
|
|||||
|
|||||
![]() I place my heavy rocks on a sheet of acrylic. The parts that get exposed by the fish and powerheads typically encrusts with coraline so it blends in with the rock and tank bottom if it has been exposed too.
|
#6
|
||||
|
||||
![]() I use it on all my tanks. Cheep insurance IMO.
|
#7
|
|||||
|
|||||
![]() a couple of inches of sand will cushion the rocks from creating any stress concentration on the glass. My only fear with eggcrate is that it's just another place to trap debris that can't be siphoned out and sand sifters won't be able to get to it. I guess it would help in the event of a rock slide but I've never heard of stationary rocks on a sandbed cracking glass.
|
#8
|
|||||
|
|||||
![]() I would never put rocks on sand again, I had a tower collapse as the sand shifted under it. Probably induced by some livestock, but it was a mess. Didn't hit glass, but from now on my rock sits on solid footing and sand goes in second.
__________________
Brad |
#9
|
|||||
|
|||||
![]() when I had a DSB built boxes with egg-crate and zipties for the rock to sit on so the bottom 4" wasn't buried in sand.
With the new tank and BB, rock just sits directly on the glass.
__________________
my tank Last edited by mark; 12-09-2010 at 09:25 PM. |
![]() |
Thread Tools | |
Display Modes | |
|
|