Canreef Aquatics Bulletin Board  

Go Back   Canreef Aquatics Bulletin Board > General > Reef

Reply
 
Thread Tools Display Modes
  #1  
Old 10-07-2010, 02:47 AM
Lampshade's Avatar
Lampshade Lampshade is offline
Member
 
Join Date: Aug 2009
Location: Abbotsford
Posts: 629
Lampshade is on a distinguished road
Default Calcium Reactors

I'm setting up a new tank next week and have a calcium reactor all ready to go. My question to people with reactors: Do you suppliment to raise PH? Would it be worth running a kalkwasser reactor for auto top off to help balance my PH? My tank's going to start pretty lightly loaded, VERY light loaded for calcium since most coral is LPS right now. Should i just set a slow drip and see how it goes? I've got everything to set up a DIY kalk stirrer, would it be worth building into my ATO system? Any feedback would be great, thanks
__________________
My 150 In Wall Build
Reply With Quote
  #2  
Old 10-07-2010, 03:15 AM
whatcaneyedo's Avatar
whatcaneyedo whatcaneyedo is offline
Member
 
Join Date: Apr 2007
Location: Prince George, BC
Posts: 2,198
whatcaneyedo is on a distinguished road
Send a message via MSN to whatcaneyedo
Default

It depends on the atmospheric CO2 in my home. In the summer I have no problem keeping my pH in the 8.1-8.3 range with a window open. In the winter I go down to 7.8-8.1 and I use both a calcium reactor and a kalkwasser reactor. Start slow and measure your alkalinity weekly. Once you get the reactor dialed in you can be more lax.

A Guide to Using Calcium Reactors
http://reefkeeping.com/issues/2002-0...ture/index.php

Low pH: Causes and Cures
http://reefkeeping.com/issues/2004-09/rhf/index.htm
__________________
"We shall dive down through black abysses... and in that lair of the Deep Ones we shall dwell amidst wonder and glory forever." - H.P. Lovecraft

Old 120gal Tank Journal
New 225gal Tank Journal
May 2010 TOTM
The 10th Annual Prince George Reef Tank Tour
Reply With Quote
  #3  
Old 10-07-2010, 03:29 AM
mark's Avatar
mark mark is offline
Member
 
Join Date: Nov 2002
Location: Edmonton AB
Posts: 4,212
mark is on a distinguished road
Default

My pH stays okay just with the reactor.

Hint for them though, reactors used to maintain Ca levels, so supplement first to get your level where you want. Found pushing easy to spike the alk.
__________________
my tank
Reply With Quote
  #4  
Old 10-07-2010, 03:55 AM
Dez's Avatar
Dez Dez is offline
Member
 
Join Date: Mar 2002
Location: Edmonton
Posts: 1,793
Dez is on a distinguished road
Default

Ifyou add a second chamber to your reactor it helps too. Just put the calcium reactor media in the second chamber and you're good to go. It helps a bit.
Reply With Quote
  #5  
Old 10-07-2010, 09:24 AM
Lampshade's Avatar
Lampshade Lampshade is offline
Member
 
Join Date: Aug 2009
Location: Abbotsford
Posts: 629
Lampshade is on a distinguished road
Default

Thanks all, i've got a second chamber for my reactor, i'll just see how it goes.

Didn't think about the initial setup, thanks for the tip, makes sense that you want the reactor to maintain the Calcium, so using it to build up in the beggining will not help dialing it in.

And i've heard that fresh air in the house makes a differance, didn't think it would effect the tank that much, might explain some movements i have right now.
__________________
My 150 In Wall Build
Reply With Quote
  #6  
Old 10-07-2010, 12:52 PM
BlueTang<3's Avatar
BlueTang<3 BlueTang<3 is offline
Member
 
Join Date: Mar 2009
Location: Stony Plain, Alberta
Posts: 1,641
BlueTang<3 is on a distinguished road
Default

I punched a hole in the side of the house so i could bring air in for my skimmer. Great in the winter took it off in the summer as i was getting funny ph swings with storms and when people sprayed there weeds.
__________________
360 gallon sps reef, 180 gal sump, bubble king supermarine 300, 4xmp40Wes, 2 x 6215 tunze waveboxes, 4 ghl mitras



360 Reef Tank
Reply With Quote
  #7  
Old 10-07-2010, 04:24 PM
StirCrazy's Avatar
StirCrazy StirCrazy is offline
Member
 
Join Date: Oct 2001
Location: Kamloops, BC
Posts: 7,872
StirCrazy is on a distinguished road
Default

if you have a very light Ca load right now you might be able to get away with just a Kalk reactor. then use the Ca reactor later when your demand warents it.

I would not run one with out the other but that is just my opinion and others have run Ca reactors alone, but some people run a Ca reactor then just add kalk to there top off water, so same result.

Steve
__________________
*everything said above is just my opinion, and may or may not reflect the views of this BBS, its Operators, and its Members. If cornered on any “opinion” I post I will totally deny having ever said this in a Court of Law…Unless I am the right one*

Some strive to be perfect.... I just strive.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT. The time now is 10:27 PM.


Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.