Pretty Dumb Question

[Wayne]

LOL most lids nowadays you have to remove the bottom 1cm usually by pulling the strip off then just pry up on the 6 or so tabs... What brand? Picture?

[Snufflupagus]

Lol if it's like the buckets I have you should be able to just screw off the lid.

[Eb0la11]

Its different from both lids you guys have described. Theres no tab to pull on that would remove a 1 inch strip, and the old screw ones, which Im familiar are no longer being used, apparently...

This new one is basically just like a sleek kind of looking lid that doesnt budge...

[Wayne]

Tiger Torch! Pretty sure it will come off within a minute

Good luck hopefully someone else has come across!

[Eb0la11]

I think this one is just missing the tab or something, maybe a defective lid, there seems to be a seem that a tab would open along. I'll figure it out. Might just have to hack job this one.

[Wayne]

Originally Posted by Eb0la11

I think this one is just missing the tab or something, maybe a defective lid, there seems to be a seem that a tab would open along. I'll figure it out. Might just have to hack job this one.

If there is a seam then get the side cutters out and make a tab to pull on...

[fishoholic]

Try hitting the inside ridge on the top of the lid with a hammer, if it's a twist top lid, or hit the bottom of the lid in an upwards motion with a hammer if it's a pull off lid.