THE Tank Build By Aqua Digital

[superduperwesman]

Looking good. Anyway you can run the cords inside the tubing?

[bauder1986]

one of the cleanest looking nano's out there

[Aqua-Digital]

Thanks

Yes the wires will be rooted once i am happy with the height of the lamps, I still think they may have to go up by 3" which means raising the bars.

The back will be Black by Monday also, so no wires

[superduperwesman]

NOOOO! The height of the lights looks good how it is, but I guess you gotta do what you gotta do

[Aqua-Digital]

LED by nature can create "spotting" where the two colours do not blend, to account for this you have to adjust the height. At present they are as high as I wish to go but am still seeing some blue/white seperation. I will test today what height is required to get the ultimate blend

[Aqua-Digital]

Just planning the auto water change now and then in April the balling chambers The AWC programmed and controlled by the profilux will be as follows

1/4 Ro line gravity drained from sump to basement about 12' below direct to drain, this will be controlled by a solenoid. The ATO sensor will be switched to dual mode ATO/AWC and a second low sensor for the AWC lower limit draw off.

In the coat closet behind the tank will be a large (ish) vat, this will at present plans feed the tank with new water via a tiny power head. The tank will drain and replace 1L twice a day so approx 10% a week.

Due to only draining off 1L at a time the tank will not have to have any equipment down time making the water change process and programming very simple.

[Aqua-Digital]

Hanging wire tails now hidden