How would you setup this sump?

[Myka]

Ok that's a bit weird. The baffles seem too high to be very effective, and the chamber that I would want to use for a skimmer doesn't look big enough. I would be tempted to pull out the baffles, trim some down, move them around a bit, and get a few new ones made. What's with the two baffles in the back after the eggcrate that neither go to the bottom?

[canadian_srt4]

Originally Posted by Myka

Ok that's a bit weird. The baffles seem too high to be very effective, and the chamber that I would want to use for a skimmer doesn't look big enough. I would be tempted to pull out the baffles, trim some down, move them around a bit, and get a few new ones made. What's with the two baffles in the back after the eggcrate that neither go to the bottom?

my drawing may not be to scale sorry, I just did this fast in photoshop.

As for the 2 in the back.... no idea. Its hard to know what someone had planned when you were not there while it was being built.

Hence the reason I'm asking here for help.

[Myka]

Re: the two in the back...that was a rhetorical question. Kinda me goin "huh?"

Could you do some measurements of the baffles to find out how tall they are (just the ones that go to the bottom)?

I'm thinking the front compartment where the tall baffle is was planned to be a refugium. Then I think the water is supposed to come in through that chamber next to it, go through some filter media into the centre chamber. I think the centre one is for the skimmer, and then the water goes out through the left. I would add another baffle on the left before the water goes out.