![]() |
|
Portal | PhotoPost Gallery | Register | Blogs | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
|
Thread Tools | Display Modes |
|
#1
|
|||||
|
|||||
![]() ![]() Post up your heat tested PO4 results, will be interesting to see the difference. |
#2
|
|||||
|
|||||
![]() Well, I heated the water till just started to see a couple boil/ let cool, about 4 hrs. The reading is off the chart. I would guess 6-7 judging by the shade increase from the last one on the test sheet.
Now, if heating it gives true PO4, why doesn't the directions call to heat it? I mean, if the kit is not accurate as described? Thought Salfert was one of the good brands.
__________________
Dan Pesonen Umm, a tank or 5 |
#3
|
|||||
|
|||||
![]() Hiya
You may have over played it a bit, only let stand for 5 mins then test this is important. In regards to why manufacturers do not advertise this fact, i have no clue, but one thing for sure is that when fauna release all their range of test kits you will have all info available to you on how to perform accurate tests |
Thread Tools | |
Display Modes | |
|
|