Tank transfer didn't go well

[Leah]

Sometimes it can really suck, good luck with all the rest hope it get's better.

[GreenSpottedPuffer]

Well I can add a few digitata to the list and two cap frags

Hope this doesn't keep getting worse.

I just don't see what I did wrong.

[Borderjumper]

Ive done 3 tank transfers and never had anything skip a beat. Only thing I did different from you was I didnt transfer ANY sand.. I bought new.

Was there lottsa crap in the sand and did it rinse pretty clean?

How does the tank test today for ammonia or nitrates?

[GreenSpottedPuffer]

Originally Posted by Borderjumper

Ive done 3 tank transfers and never had anything skip a beat. Only thing I did different from you was I didnt transfer ANY sand.. I bought new.

Was there lottsa crap in the sand and did it rinse pretty clean?

How does the tank test today for ammonia or nitrates?

The sand was very clean. I was surprised. I only used the very top layer. When I "cleaned" it, the water I cleaned it in, only got a slight beige color. This sand that I used was only in my old tank about a month.

I checked nitrates and they were 5 but I haven't checked ammonia. I will check everything again now.

[GreenSpottedPuffer]

Temp. 79
SG. 1.027 (a little high I know)
PH 8.4

Ammonia 0
Nitrite 0
Nitrate 8
Alk 7.5

[Borderjumper]

after you skimmed off the top layer of sand did you use the water? Jeeze how can I type this so it makes sense, its harder to type than to talk

The top layer of sand is usually cleaner, not only visually but bacterially.. so when you skimmed off the top layer maybe leaving the bottom gunge layer exposed released somthing into the water.. or did you not use that water?

[GreenSpottedPuffer]

Originally Posted by Borderjumper

after you skimmed off the top layer of sand did you use the water? Jeeze how can I type this so it makes sense, its harder to type than to talk

The top layer of sand is usually cleaner, not only visually but bacterially.. so when you skimmed off the top layer maybe leaving the bottom gunge layer exposed released somthing into the water.. or did you not use that water?

No didn't use that water. I transfered everything over to the new tank except the sand and about an inch or two of old water. Then I siphoned out the top layer of sand and the rest of the water to a bucket. Rinsed it out in there, sand went to the new tank, water was thrown away. So even if it released anything into the water, that water was never used.

[Delphinus]

I'm sorry to hear this. My guess is it's a cycle of some kind. If it were me, I'd throw some Cycle or some Zeobak or whatever into the water, I figure it couldn't hurt. Good luck!

[GreenSpottedPuffer]

Originally Posted by Delphinus

I'm sorry to hear this. My guess is it's a cycle of some kind. If it were me, I'd throw some Cycle or some Zeobak or whatever into the water, I figure it couldn't hurt. Good luck!

Yeah maybe. If it was though, it was very small. Not to mention, some of my more delicate SPS are fine. Its not like all the delicate stuff died and the hardy stuff made it. Actually almost the other way around. Most of the dead sps are tough species.

I have noticed one more acro now that looks to be receding from the tips a bit. Should I frag the branches off now do you think??? This is another of my favorites

[High tide]

That totally sucks! What kind of salt did you use? Generally a bad idea to reuse sand, it upsets the ecology and things you can't even see die by the thousands. That being said, I've done it successfully several times. I think it could be shock from the transfer and such a large water change at the same time.