Not a whole lot different as far as my build goes. I've been busy getting the stand ready for the tank which should be in my hands sometime next week.
This is the completed stand with 3 coats of melamine and all cracks and bottom joints sealed with silicone. You can barely see the 1" drain opening in the back right. The idea is that any mishaps drain directly to the basement thus avoiding the wife's wrath. The stand can hold around 2" of water itself. I will perform water changes by opening a valve that feed a 1/2" pipe hovering just over the 1" drain hole.
Better look at the swissboard backing. The smaller holes are for letting heat out of the back while keeping my cats out of the stand. The large openings are to allow the drain lines to feed the sump. I imagine I might end up using a few of the vent holes as well for running pipes.
A look behind the stand which is set to allow for 6" deep external overflow. I'm not exactly sure what size the overflow will be but I can slide the stand to give me anywhere between 4" and 10" so I have my bases covered.
05-22-2008, 04:02 AM
Hybrid Mode
