calciuum reactor help

[adidas]

Originally Posted by Delphinus

There's nothing on the guage itself that says what the units are?

lol it's all in chinese or something.. all i know is that the BPM is around 70-80...is there any dangers of having it run the way it is? the effluent is running at about the same speed as a 100gpd RODI filter

[Delphinus]

Originally Posted by adidas

lol it's all in chinese or something.. all i know is that the BPM is around 70-80...is there any dangers of having it run the way it is? the effluent is running at about the same speed as a 100gpd RODI filter

My guess is the units then are probably "thousands of kPa". The bubble rate is not abnormal. So long as your effluent pH is at 6.7 (or where-ever you want it set at), it should be pretty safe.

Assuming you get 100gpd out of your 100gpd RO/DI (usually you don't get the full flowrate out of those things, but let's just ignore the details for the sake of guesstimating the flowrate ) that's. . um .. 100gpd =~ 400 litres per day = 400,000 ml per 24 hours ~270 ml per minute (1440 minutes per 24 hours). Hmmm, ok, that seems a little fast.

60ml/min is basically on right on the verge of starting as a steady stream, whereas any slower it's actually perceivable as a "fast drip-drip-drip-drippety-drip."

Basically I'd just take a known volume container (measuring spoon, measuring cup, whatever), and count how long it takes to fill up to a certain level, from that you can figure out your flowrate.

[adidas]

Originally Posted by Delphinus

My guess is the units then are probably "thousands of kPa". The bubble rate is not abnormal. So long as your effluent pH is at 6.7 (or where-ever you want it set at), it should be pretty safe.

Assuming you get 100gpd out of your 100gpd RO/DI (usually you don't get the full flowrate out of those things, but let's just ignore the details for the sake of guesstimating the flowrate ) that's. . um .. 100gpd =~ 400 litres per day = 400,000 ml per 24 hours ~270 ml per minute (1440 minutes per 24 hours). Hmmm, ok, that seems a little fast.

60ml/min is basically on right on the verge of starting as a steady stream, whereas any slower it's actually perceivable as a "fast drip-drip-drip-drippety-drip."

Basically I'd just take a known volume container (measuring spoon, measuring cup, whatever), and count how long it takes to fill up to a certain level, from that you can figure out your flowrate.

ok thanks..i will do that.

[adidas]

well it did 88ml in 15 secs LOL, I think that is too fast

[mark]

Make sure you also kept an eye an your Alk. Found with my reactor if pushing it, very easy to spike the Alk.

[adidas]

Originally Posted by mark

Make sure you also kept an eye an your Alk. Found with my reactor if pushing it, very easy to spike the Alk.

alk should be around 9-11 dkh right?

[mark]

Originally Posted by adidas

alk should be around 9-11 dkh right?

Good range, NSW is something like 8 dKH.