|
|
|
||||||||
| Portal | PhotoPost Gallery | Register | Blogs | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#2
10-25-2007, 11:58 PM
|
|||||
|
|||||
From what ive seen of the two the Tunze 6025 shoots out more of a cylindrical stream whereas the korolia 4 is more of a cone shape (almost shoots out in a 180 degree angle from the impeller) and does not travel as far. In my case, a 20g i didn't want to have more than one powerhead so the tunze won because it could penetrate deeper and created less dead spots in my tank (i still have a few im fighting with). Maybe you could up the size to a 3 or 2, but i had corals too close to the powerhead that couldn't handle the flow.
|
|
#3
10-26-2007, 12:46 AM
|
|||||
|
|||||
|
nanos
Are these mainly with the 6025s or with other models such as the 6045s and 55s?
__________________
300 Gal 6x3x28 high Starphire peninsula w/external herbie/bean animal hybrid +150 Gal custom sump with 30gal fuge section, (both built by Concept Aquariums Calgary), 3x Ecotech Radion xr30w g2's(soon to be G3 Pros), Jebao DCT 12000 return pump, 2x Jebao RW 20 powerheads, Tunze Ato, Vertex ro/di, Reef Octopus Ext 200 skimmer run internally.
|
|
#4
10-26-2007, 04:38 AM
|
|||||
|
|||||
|
The problems you mean? Unfortunately, these occur throughout the entire nanostream line.
Quote:
__________________
50G reef + 20G sump
|
|
#5
12-15-2007, 11:55 PM
|
||||
|
||||
|
I have been running 4 6055's on a multi controller for a while now. I have had no problems with them so far. It is still a toss up to me though wether they work better all running full bore with out the controller, or if the random alternating flow is better.
|
|
#6
12-16-2007, 12:08 AM
|
||||
|
||||
|
6025 and 6045
I went through several pumps...had all my original 6 replaced...and all the replacements broke too..the impeller shaft snapped off (rusted) at the base.
Also had at least half of the c-clamps break...finally gave up and traded up to 6100's and a controller...needed more flow anyway...but I think there must be a design flaw with the nano's..Karen
__________________
klm Edmonton, Ab
|
|
#7
12-16-2007, 12:25 AM
|
||||
|
||||
|
http://www.reefcentral.com/forums/sh...readid=1025361
I've been running a 6025 and a 6045 for a couple months now. I cut them both up as soon as I got them, and haven't had any problems with them since. They were both purchased after september 07 and both have the round power cords. One of them started in reverse for me once, I put my hand in front of the outlet and the prop started spinning the right direction right away.
|
|
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
