Profilux II plus aquarium controller

[himat]

thank you
Matthias Gross

i have used one relay for one ballast ,i didn 't know that my lights where configured so one tube from each side come on with one ballast,
works better than i thought.

i know need to find out how long i need to burn the tubes before dimming
these are Giesemann Infiniti range 60cm. i have set 100 hrs from the manual of the profilux.

thanks
himat

[Matthias Gross]

100 hours are ok for burning in

And finally:
The WLAN/LAN-tutorial can be dowloaded here:
http://www.ghl-kl.de/Produkte/Aquari...AN_new_eng.pdf

Please excuse this translation to english - in a next step we will get it "debugged". But it was important to publish this doc ASAP and i think it can be understood.

[Lam'sreef]

I still confuse with how to set up.
How do set set the IP address? where do I get the IP address from?or just set any number? how come this thing so complicated?
Matthias, is there a customer service or phone number I can call to get help for setting up?

Thank you

Lam

[Matthias Gross]

Please give me details about your complete home network.

[Lam'sreef]

I have no idea about home network, what I have and used now is the computer hook up to the DSL router.
I follow the instruction to set up the ProfiLux Plus II controller to 2.2 and then I got loss.
Please tell me what I need and how to set this thing up.
I thought these thing should be plug and play.

Thanks

Lam

[Matthias Gross]

I wonder how it was possible to hook up the PC to the router without doing any settings or whaving any knowledge about the network. Is the WLAN security deactivated as standard? This is not recommended.
If this is the case it is very simple to get the connection running.
The only thing you must know: what are the IP-addresses in your network?
I'll send you now a PM with my phone-number, please call me.

[bullit67]

Well it has been about 3 months or so since I have been on this forum I had some computer problems and then just a pure lack of time. Good to see the profilux thread is still alive and well good to see so many firmware updates and that is where I have a question I am still running the firmware that came with my unit Can I upgraed strait to 3.03.1 or do I have to go through the other versions first? ( I hope not ) Also the english site goes strait to 3.02 I beleve it is. Any reason for this or has the site just not been updated yet

Thanks
Doug