Profilux II plus aquarium controller

[himat]

Matthias Gross

i have read the spec sheet for this and would like to know if it was possible to connect two ballasts to one relay control set leaving one side unsed.
i am aiming to utilize one port to control two ballasts from the profilux , and then add a led bar on the second port,using a splitter YL2.

Himat

[Matthias Gross]

You can connect several ballasts to one EVG-AP output. The only limitation is the inrush current of all connected ballasts (in sum). It must not exceed 100A, with good ballasts you should not have a problem with up to 5 ballasts on one relay. The inrush current of a ballast is usually given in the datasheet.
But why do you want to use a splitter and only one relay? Do you use L3L4 for other devices? If not there is no need for this configuration.

And: The new (W)LAN-tutorial - german version - is finally ready. Today we translate it, in the evening we will publish the english version. I'll post later again when it can be downloaded.

[himat]

thank you
Matthias Gross

i have used one relay for one ballast ,i didn 't know that my lights where configured so one tube from each side come on with one ballast,
works better than i thought.

i know need to find out how long i need to burn the tubes before dimming
these are Giesemann Infiniti range 60cm. i have set 100 hrs from the manual of the profilux.

thanks
himat

[Matthias Gross]

100 hours are ok for burning in

And finally:
The WLAN/LAN-tutorial can be dowloaded here:
http://www.ghl-kl.de/Produkte/Aquari...AN_new_eng.pdf

Please excuse this translation to english - in a next step we will get it "debugged". But it was important to publish this doc ASAP and i think it can be understood.

[Lam'sreef]

I still confuse with how to set up.
How do set set the IP address? where do I get the IP address from?or just set any number? how come this thing so complicated?
Matthias, is there a customer service or phone number I can call to get help for setting up?

Thank you

Lam

[Matthias Gross]

Please give me details about your complete home network.

[Lam'sreef]

I have no idea about home network, what I have and used now is the computer hook up to the DSL router.
I follow the instruction to set up the ProfiLux Plus II controller to 2.2 and then I got loss.
Please tell me what I need and how to set this thing up.
I thought these thing should be plug and play.

Thanks

Lam