Profilux II plus aquarium controller

[support@proline]

Matthias
By just my 2 cents ginzo means his opinion & input
Go easy with the lingo on the german guy here people
Ginzo good feedback .

[niloc16]

i have a question for you matthias, i have the view II for the controller as well and it is mounted on the end of my canopy on the outside for easy access. at night the glow from this unit is extremely bright, is it possible to have the controller shut off the view II at night or a pre-programmed time?

[Matthias Gross]

@Jason: I think i know the meaning...I hope so

@Ginzo: A lot of input for me. I will check the recommendations. For level control: some extensions in the firmware are allready planned.

@niloc: Not possible, sorry.

[Jukka]

Would it be possible to have 0,01 second adjustment for current/ short wave?
0,1 s is little coarse for Tunze wavebox...

[Matthias Gross]

Jukka,

the time which has to be entered in 0.1s steps in the ProfiLux is the wave duration ( = pulse + pause). That means that the pulse duration is adjustable in 0.05s steps in truth.
Until now we got only positive feedback from our customers regarding wave-box control. They have all been able to adjust the time adequate to their tank, and they had tanks with different lengths (appr. 60cm ... 300cm).
->The resolution will not be changed in future (except a customer complains that he is not able to adjust his wavebox control satisfying)

[Jukka]

OK, i think my wave setting is fine at 2.0s. The reason why i asked this is because 1.9 and 2.1 are both way of, so there could be little optimization left, maybe . I am happy with the control though.

[AMP]

Good day all,

I am writing from the states, Not to switch channels on your subject, But i am in my lighting phase of my new rig, And I am curious as to which dimmable ballasts are compatible for the Profilux? More or lesss i keep getting a round about answer that most of the dimmable balasts that are 0-10V capable are fine, but I am also being told the Dimming module is 5 Wire.

Is there a schematic that can be found?

Thanks for any input on this,

Tony
http://s85.photobucket.com/albums/k4...090%20Project/