Wavysea screw specs

[Chin_Lee]

If you ever plan to make your own Wavysea holders for the oversized brackets,
a) the three smaller screws that attach the Wavysea holder to the bracket will need a tap size of 6 x 1mm and predrill of 13/64" hole
2) the two larger screws that applies pressure to the tank's edge and bracket will need a tap size of 8 x 1.25 mm with predrill of 17/64" hole.

I made one out of 1/4" acrylic and I bent it over a 1" thick square frame. Make sure you keep the short edge flat.

This is just an information post for you DIYers and for me to refer to in the future.