question about remora skimmers

[Todd]

While on the same thread search someone mentioned putting a piece of foam over the return (similar to the ones you would see on an aquaclear). They mentioned that they just cleaned it once a week or so. Seems like it would work although I haven't tried it yet. The Microbubbles are quite annoying, and are much more noticeable on my tank now that it is a room divider with no wall behind it.

[albert_dao]

Make sure your hands are super clean before you put them into your tank. Also, if you use really fatty foods like mysis, it's going to hamper the performance for at least a few hours. Just wash your frozen foods off before you use them to minimize that.

[fkshiu]

The slit filter sponge over the output lip works very well for microbubbles.

Remoras are very sensitive to oils in the water so try to minimize that whenever possible.

[goby1]

I used to get a lot a micro bubbles with my Remora when it was new but there are none now. Also, after I clean it there's micro bubbles but after a few days there's nothing. If you give it some time they will probably disappear.

Beware of anything in your tank with any kind of oil residue- when I changed the foam pads in my filter it literally didn't skim for almost 6 weeks (and I had rinsed them well). I did water change after water change and was starting to panic but it did kick in again eventually. At the time I was really unimpressed but all in all, it's been a good skimmer for what I have (46 g).

[Raf]

I am curious,

where in the skimmer is the injector located so I can clean it?

[ryanfish]

Originally Posted by Raf

I am curious,

where in the skimmer is the injector located so I can clean it?

Look inside the skimmer and you should see a a white plastic screw on the intake pipe. Take the screw off and stick the brush (that came with the skimmer) inside the hole and start cleaning. If you dont have the brush you can get some sort of pipe cleaner brush at your local hardware store (i think).

[OCDP]

Originally Posted by ryanfish

Look inside the skimmer and you should see a a white plastic screw on the intake pipe. Take the screw off and stick the brush (that came with the skimmer) inside the hole and start cleaning. If you dont have the brush you can get some sort of pipe cleaner brush at your local hardware store (i think).

Haha , edit: relalize I basically just said everything you did