![]() |
#21
|
|||||
|
|||||
![]() You're welcome, Marcus
![]() Here is the link for the RC thread on washing soda ("baked" baking soda) and baking soda. It contains a link to one of Randy's articles ![]() http://www.reefcentral.com/forums/sh...shing+soda+mix |
#22
|
|||||
|
|||||
![]() Quote:
I have recently begun using a regiment of combined Turbo Calcium and Kalk to buffer my tank. Its taken a while but my levels are slowly but steadily increasing from the 310ppm mark up to 360 as of yesterday. Its a lot cheeper than liquid suppliments.
__________________
THE BARQUARIUM: 55 gallon cube - 50 lbs LR - ASM G3 skimmer - 30 Gallon sump - 22 Gallon refugium / frag tank - 4x 24 watt HO T5's - Mag 9.5 return - Pin Point PH monitor - 400 watt XM 20K MH in Lumenarc reflector - Dual stage GFO/NO3 media reactor - 6 stage RODI auto top up -Wavemaster Pro running 3 Koralia 2's. Fully stocked with fish, corals and usually some fine scotch http://www.canreef.com/vbulletin/showthread.php?t=55041 |
#23
|
|||||
|
|||||
![]() My cheap dosing routine:
- Food grade Calcium Hydroxide (Kalk) for all topoff - Arm and Hammer baking soda for buffer - Bulk Calcium Chloride from swimming pool supply store (tip courtesy of Chin Lee) I make up liquid solutions in advance for easy dispensing. |
#24
|
|||||
|
|||||
![]() I was actually wondering about adding baking soda to the kalk water after mixing it, to nutralize the ph a bit. Are there any ill effects from doing this in your experience?
__________________
THE BARQUARIUM: 55 gallon cube - 50 lbs LR - ASM G3 skimmer - 30 Gallon sump - 22 Gallon refugium / frag tank - 4x 24 watt HO T5's - Mag 9.5 return - Pin Point PH monitor - 400 watt XM 20K MH in Lumenarc reflector - Dual stage GFO/NO3 media reactor - 6 stage RODI auto top up -Wavemaster Pro running 3 Koralia 2's. Fully stocked with fish, corals and usually some fine scotch http://www.canreef.com/vbulletin/showthread.php?t=55041 |
#25
|
|||||
|
|||||
![]() Quote:
From my experience systems tend to run lower than pH 8.2-8.3 and kalk can be beneficial in raising it. Unless you have identified an 'abnormal' pH level as the cause of a problem I would'nt get too creative in trying to obtain textbook levels. Often it can do more harm than good. If you have to lower your pH due to Kalk use then I suggest adding vinegar to the kalk mixture POST mixing. |
#26
|
|||||
|
|||||
![]() Good to know. I have added vinegar in the past but I am always hesitant because, well, its vinegar. Thanks!
![]()
__________________
THE BARQUARIUM: 55 gallon cube - 50 lbs LR - ASM G3 skimmer - 30 Gallon sump - 22 Gallon refugium / frag tank - 4x 24 watt HO T5's - Mag 9.5 return - Pin Point PH monitor - 400 watt XM 20K MH in Lumenarc reflector - Dual stage GFO/NO3 media reactor - 6 stage RODI auto top up -Wavemaster Pro running 3 Koralia 2's. Fully stocked with fish, corals and usually some fine scotch http://www.canreef.com/vbulletin/showthread.php?t=55041 |
#27
|
|||||
|
|||||
![]() Quote:
You've got to read the links I provide ![]() High pH: Causes and Cures: http://reefkeeping.com/issues/2005-03/rhf/index.htm Quote:
|
#28
|
|||||
|
|||||
![]() Quote:
![]() Steve
__________________
![]() Some strive to be perfect.... I just strive. |
#29
|
||||
|
||||
![]() Vinegar is great for lowering ph of kalk, just use the same brand pictured in that article; "Heinz pure white vinegar" or any other distilled brand. In addition to this, it also helps dissolve kalk mix more readily even the "kalk" sludge in the bottom of your kalk bucket/container. (I think this info is in one of the articles listed by Beverly as well.) If you follow the suggestion of 45ml vinegar/gallon using a 2tsp/gallon (10mg/gallon) kalk mix, you'll get a fairly "safe" solution to add to your tank once everything settles. You can add it all at once considering you have a larger tank (100+ gallons); use a drip line anyway but open it fully. Should take about an hour to empty 5 gallons of kalk mix this way.
Although vinegar does reduce alkalinity, the effect is negligible in Calgary as our water is REALLY hard from 122-248 mg/L or ppm (6.8-13.8 dKH). Your exact range depends on what reservoir your water is drawn from whether it be from the Glenmore in the South (very hard water) or Bearspaw reservoir in the North (not as hard as the south). Hopefully this puts your mind at ease next time you consider adding vinegar. |
![]() |
Thread Tools | |
Display Modes | |
|
|