Canreef Aquatics Bulletin Board  

Go Back   Canreef Aquatics Bulletin Board > General > Tank Journal

Reply
 
Thread Tools Display Modes
  #1  
Old 11-28-2016, 09:32 PM
NastayNatron's Avatar
NastayNatron NastayNatron is offline
Member
 
Join Date: Jan 2011
Location: Calgary
Posts: 162
NastayNatron is on a distinguished road
Default

Time for an update! I have completed the equipment side of my reef . I ordered dosing pumps from BRS and programmed them with my Cerebra. Its been nice to be done with daily manual dosing! I completed my "electrical cabinet" on the upper side of the right cabinet with the addition of a Vortech Battery Backup.





I created a cover utilizing a left over shelf from the cabinet and white trim. I mounted a small brushed nickel knob on the left for easy removal. The cover clicks easily into place using cabinet magnets which I mounted in the corners. It makes it look pretty clean.





I also added a second power bar for my Cerebra. 6 outlets was not enough with the first one. I did not have a lot of options for mounting the power bar due to size constraints. I removed the liquor from the middle of the stand along with the middle shelf. I used the same method for mounting the first power bar as you can see below. I then notched a section out of the shelf before putting it back in place. It looks great and actually did not take up a lot of room in the back. It is totally invisible once the bottles are back in place!





As for dosing containers, I went with Vertex Libra Vessels. They look good and are easy to work with. On the right, I installed a trigger systems crystal 5 gallon ATO reservoir. Check it out!





Reply With Quote
  #2  
Old 11-28-2016, 09:36 PM
NastayNatron's Avatar
NastayNatron NastayNatron is offline
Member
 
Join Date: Jan 2011
Location: Calgary
Posts: 162
NastayNatron is on a distinguished road
Default

And a few more shots





Reply With Quote
  #3  
Old 11-28-2016, 10:02 PM
Stones's Avatar
Stones Stones is offline
Member
 
Join Date: Jan 2006
Location: Regina, Saskatchewan
Posts: 401
Stones is on a distinguished road
Default

Awesome looking build! You really accomplished a lot with such a small space to work with. I've always been impressed by Concept's builds and yours turned out great.

Where did you find the Kessel H-150?
__________________
Do or do not....there is no try.
Reply With Quote
  #4  
Old 11-29-2016, 01:37 PM
wayner's Avatar
wayner wayner is offline
Member
 
Join Date: Jan 2002
Location: Calgary, McKenzie Towne SE
Posts: 634
wayner is on a distinguished road
Default

Great job Nate
Reply With Quote
  #5  
Old 11-30-2016, 12:55 AM
NastayNatron's Avatar
NastayNatron NastayNatron is offline
Member
 
Join Date: Jan 2011
Location: Calgary
Posts: 162
NastayNatron is on a distinguished road
Default

Quote:
Originally Posted by Stones View Post
Awesome looking build! You really accomplished a lot with such a small space to work with. I've always been impressed by Concept's builds and yours turned out great.

Where did you find the Kessel H-150?
Thanks. I picked up the Kessel on Amazon actually. I can't remember the price but it wasn't that bad.


Quote:
Originally Posted by wayner View Post
Great job Nate
Thanks!
Reply With Quote
  #6  
Old 11-30-2016, 01:31 AM
kien's Avatar
kien kien is offline
¸.·´¯`·.´¯`·.´¯`·.¸¸.·´¯`·.´¯`·.´¯`·.¸¸.·´¯`·.¸¸. ><(((º>
 
Join Date: Apr 2009
Location: Calgary, AB
Posts: 7,665
kien will become famous soon enoughkien will become famous soon enough
Default

Nice build. So clean and precise, as if it was all planned out or something :-)
Reply With Quote
  #7  
Old 12-04-2016, 11:14 PM
NastayNatron's Avatar
NastayNatron NastayNatron is offline
Member
 
Join Date: Jan 2011
Location: Calgary
Posts: 162
NastayNatron is on a distinguished road
Default

Alright I've had my Vertex Cerebra Controller up and running on my tank for a little while now so I think its time I post a review. This won't be super in-depth, but for anyone considering eventually buying this controller, it could be helpful.

What I have:

Vertex Cerebra Controller
6 outlet multi bar
6 outlet power bar
Temperature Probe
Dual Junction PH Probe (Neptune not Vertex)

First impressions: As with all Vertex products, the Cerebra came packaged very well and looked great. You could probably drop the box off a building and I'm sure everything would still be in tact! As for initial setup, it wasn't too bad. Mounting the multi-bar was a bit of a pain. In order to get the mounting hardware installed, you must remove the end cap off of the bar. This isn't a big deal, but being instructions for this are not included, it took me a few minutes to figure it out. One thing that was a hurdle for me was the size of the power bars. The multi bar includes 6 outlets along with a good selection of other inputs for probes, floats, etc. The power bar contains just 6 outlets. I am using one of each. These power bars are 20" long. Having a nano, it was tricky to fit two of them in. I would hope that eventually Vertex will release a small 3-6 outlet power bar for nano setups.

Initial programming was fairly straightforward. I just used the touch screen with the stylist provided and that worked well enough for me. You can plug a mouse and keyboard directly into the display to speed things up. You can also remote into the screen if you use the VNC server option. I found it a little simpler to set up than my Apex I had last, although that was about 5 years ago. The Apex functionality is probably a lot different now. The controller has "rules" built into its programming. They are pre-built programs and make things easy to setup. I won't go into detail on them - if you are interested, BRS did a full review on the controller and it contains all of this info.

The Wifi has worked seamlessly for me. I have been doing roughly bi-weekly updates as they come out with no real issues. Vertex is quick to act on any issues that come up. My temperature probe did not work when it arrived and they were quick to help me out. I had it shipped back to vertex with shipping labels they provided and received it back in working order within good time.

The one complaint I do have is the speed at which Vertex is developing the Cloud functionality. The cloud currently is just a preview for everyone to see the layout, but that's about it. Even e-mail and text notifications haven't gone live yet. I am hoping they are up and running by my Christmas holiday, but more than likely it will be sometime in the new year. Once the cloud comes out in full swing, I'll post a review on that side of things.

All in all, so far I am happy I went with this controller. The large, customizable screen is awesome for checking things over at a glance and commanding things on and off is quick and easy. I am not overly bothered not having notifications and the cloud functionality available yet, although with vacations coming up it is starting to bother me more. Hopefully by the summer everything will be 100%! If anyone is considering this controller and wants to know anything specific, ill try and answer as best I can!
Reply With Quote
Reply

Tags
35 gallon reef, cerebra reef, nano radion, nate's oceanfront bar, vertex reef

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT. The time now is 04:48 PM.


Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.