GHL Mitra Owners club

[KevinK]

Originally Posted by Aqua-Digital

Hi
You can set the mitras LED channels to anything you wish if you only wish to run reds and greens then this is fine just set the rest of the channels to 0% you can then adjust the red and green channels to any % intensity you wish.

I do understand that each channel can go from 0 to 100

Question is, what douse men have the red and green at,

I know this is preference, however if the average has them at 20%and there would be 7 above a tank, than in my case it would be the same as 1 at 100% (+- whatever my preference is.

Same is if in general thy have them at 50% than i would have some indication that maybe I should use 3 at 100% for each 6 at 50% on he mitras.

Sorry, the factory build units are out of my budget, and i already have a 200+ led rig, that I want to adjust a bit in to a full spectrum Unit