Canreef Aquatics Bulletin Board  

Go Back   Canreef Aquatics Bulletin Board > General > Product Review and Equipment Forum > Lighting Specific

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #13  
Old 10-07-2013, 03:52 PM
jostafew's Avatar
jostafew jostafew is offline
Member
 
Join Date: Apr 2010
Location: Abbotsford, BC
Posts: 185
jostafew is on a distinguished road
Default

I just had a similar issue; was temporarily running a 250w 20k mogul lamp (not sure what it was, think it was a Radion) in a temporary pendant, powered by a Vertex electronic ballast. When I went back to the permanent fixture on the same ballast running a (new) cheap eBay DE lamp it would start fine but after warming up would begin to flicker a little. I gave it a good couple weeks to see if it would break in, but always the same behaviour. So I swapped in an old Phoenix lamp on the same fixture and ballast and it did the same thing but not as badly. I then went back to my PFO HQI ballast on the same fixture and now both of those bulbs run fine, so in my case it was the ballast acting up.

Last edited by jostafew; 10-07-2013 at 03:56 PM.
Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT. The time now is 04:40 AM.


Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.