|
|
|
#14
10-18-2012, 03:28 AM
|
|||||
|
|||||
If you shack 2 - 3/4" pieces of plywood it will raise the bulkhead nut 1 1/2" above the stand allowing you to get to it to tighten the nut, you would have to cut at least a 4"- 5" round hole in the plywood where the bulkhead is though. I can easily make it 23" no problem.
__________________
Feed the bear goodies, make a new friend, don't feed the bear............... 8' - 165gal Reef DIY LED's Build 2012 Nano Contest Winner Febuary 2013 POTM Winner 300 gal + 60 gal Complete DIY Build 
|
Threaded Mode
