|
|
|
#13
07-08-2011, 06:46 PM
|
||||
|
||||
Dont bother with starphire for sure... Pending the shops cutting abilitys dont bother with a polish either, unless they cant cut thick glass nice...
I regularly cut 1/2-3/4" glass on my homemade air table so clean that simply running a hand sanding block w/ 220 on it to take the sharpness off you couldnt tell the different unless you weree holding a arrised and polished sample beside it... If they cant cut clean the edge will "sharks tooth" and it will look very bad and it will drive you nuts... Other wise the edge would prob be finished like any other mass made tank with a sanded edge 
|
Threaded Mode
