|
|
|
||||||||
| View Poll Results: In consideration of Tank Crashes... | |||
| My tank has suffered a full crash |
   
|
20 | 13.33% |
| My tank has suffered a partial crash |
  
|
34 | 22.67% |
| My tank has never crashed, but has potential problems |
  
|
40 | 26.67% |
| My tank is bullet proof |
  
|
16 | 10.67% |
| Crash caused by equipment failure |
  
|
21 | 14.00% |
| Crash caused by temperature deviation |
  
|
13 | 8.67% |
| Crash caused by electrical failure |
|
13 | 8.67% |
| Crash caused by system design flaw |
|
7 | 4.67% |
| Crash caused by water chemistry |
|
15 | 10.00% |
| Crash caused by low oxygen levels |
|
8 | 5.33% |
| Crash caused by disease or parasites |
|
15 | 10.00% |
| Crash caused by Old Tank Syndrome |
|
2 | 1.33% |
| Crash caused by New Tank Syndrome (rushing it) |
|
6 | 4.00% |
| The cause is not listed in this poll |
|
13 | 8.67% |
| The crash was completely out of my control |
|
9 | 6.00% |
| Multiple Choice Poll. Voters: 150. You may not vote on this poll | |||
|
|
Thread Tools | Display Modes |
|
#20
06-28-2011, 02:52 PM
|
||||
|
||||
Had a leathers vs. LPS chemical war which resulted in the LPS dead but otherwise no crashes. *knocks on tank stand* I've never had a single dead fish/invert cause problems which is nice, don't need to feel in a panic if that does happen, they pretty much just become food.
[edit] My skimmer pumped 2 gallons of water on the floor because I didn't tighten it properly one time, but luckily I only run it 12hrs on during the night so it didn't have a chance to really do much. 
|
Threaded Mode
