|
|
|
#12
06-26-2010, 03:56 PM
|
|||||
|
|||||
Whatever reactor you use, don't cheap on the pump ! Get a lot more capacity than you think you'll need. I have a TLF Phosban 150 with the 'standard' MaxiJet 1200 and I can get a max of about 200ml of pellets to tumble properly.
I'm running the valve that comes with the reactor (wide open) and will remove that completely the next time I open/clean/top-up the reactor and see if I can add a touch more pellets (250ml ?). My system volume is only around 35 gal so this isn't a problem for me but I was a little surprised by how much pump was required for such a small amount of pellets !
__________________
-Mark 29 Gal Bowfront w/24" LED Lights. DIY HOB Sump (5.4 Gal) MP40. Orange Spotted Watchman Goby, 2 Clownfish and a few hermits. 
|
Threaded Mode
