400 gallon project

[Jason McK]

Originally Posted by untamed

The tank is almost full of RO/DI water and I've added the salt. This is the salt that I am using. So far, I'm not happy with this salt.

Before I added the salt, the tank was full of crystal clear RO/DI water. After adding the salt, the tank is murky. The water is just not clear anymore. The salt has been mixing on the closed loops for 2 days now and seems fully dissolved. Jason, are you still using this salt?

In addition, look at this pile of sand and un-disolved bits (plastic maybe?) that have settled out. That all came from the salt because it wasn't there

Yes I'm still Very happy with the Ocean pure Salt. I continue to recommend it to all. I did switch back to Kent for a short while but found the dirt 100X worse than you have shown pictured above. With Kent I needed to scrub my water change bucket after every water change. I have gone through 3 buckets of OP and my mixing tank is still clean enough. Yes there is some sediment but nothing like Kent. Plus I have found that with OP I'm getting consistently good reading for everything. 470CA 8ALK 1400MG and with Kent I would lucky to get 320CA 4ALK 1150MG

these are just my experiences.


BTW your entire set up looks Fantastic.

J