|
|
|
||||||||
| Portal | PhotoPost Gallery | Register | Blogs | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
|
|
Thread Tools | Display Modes |
|
#11
01-30-2009, 05:03 PM
|
||||
|
||||
If you can get hold of an amp meter, then you can monitor your lights,pump,ect.
After your lights startup, wait for your bulbs to warm up around 5 min and then check the amp reading on each lamp. Two hours later recheck each lamp again, if the amp reading on any of the lamps go up, This mean your ballast is getting weak or short. 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode
