I am having problems getting my float valves to work. I have two valves on a splitter and the computer recognizes that I have two of them (as when I disconnect them it acts differently). But I cannot get the computer to realize the float is floating (ie tank is full), it will continue to run untill I get a time out alarm.
I have tried it with only one float and no splitter, the other with no splitter, both with the splitter. Plugging one in and resetting the computer then trying - all the same result, it will not recognize when it the valve is floating (ie when to shut off the pump). I recently had one of the valves replaced under warranty (through progressive reef). Both of the valves are clean.
I also tried upgrading to Firmware 4.04 and software 4.0.3.0 hoping that would solve things, no to no avail.
Any suggestions?
|
10-28-2008, 07:47 AM
Threaded Mode
