ya, do what I did, take both red wires and twist them togeather, then take both red/black wires and twist them togeather. wire nut each pair to a single wires and conect that to the two tips of one VHO (If you are using tombstone type bulb holders just put all 4 wires into one toombstone)
next rig a set of endcaps togeather (like a jumper) and use it to conect from the oposit end of the bulb you just put all your power to ... to then next bulb.
then take the yellow wire and with two chunks of wire split it into two ... conect this to the last end of the bulb.. this will run them in series and give you full output from a VHO.
sence this is hard to explain here is a pic to help.. might make it eayser to understand
I used the Coralife water proof endcaps, a bit pricy at 24.00/pair but the conveniance was worth it.. I just cut the wires to the lenght I wanted and conected the workhorse wires to them..
Steve
__________________
*everything said above is just my opinion, and may or may not reflect the views of this BBS, its Operators, and its Members. If cornered on any “opinion” I post I will totally deny having ever said this in a Court of Law…Unless I am the right one*
Some strive to be perfect.... I just strive.
11-08-2002, 11:09 PM
Threaded Mode
