![]() |
#21
|
|||||
|
|||||
![]() I just use it as a vibration damper, maybe a foot or two.
I found it liked to kink over time. |
#22
|
|||||
|
|||||
![]() So far I have these in mind, as far as shopping list goes:
3x bulkheads (two for drain lines, one for return) 4' PVC pipe (for the two drain lines) 4' flex PVC (for return line, I want to go this direction to lessen horizontal travel) 2x true union gate/ball valve (for main drain line flow adjustment, and one for return flow into refugium) 1x tee valve (for teeing off flow from return to refugium) 2x union (one for return pump, one for emergency drain line) PVC glue teflon tape for threads I do not plan to have a manifold at this time, since I have decided not to run biopellets, so I don't have any reactors other than a TLF for RowaPhos, and I'll just run that on its own. *stupid question* 1.5" size for all the bulkheads/pipes related to the drain, and 1" size for the return pump line? Let me know if I'm missing things ![]() |
#23
|
|||||
|
|||||
![]() We should talk/coffee before you go shopping. I'd hate to see you spend money where you don't have to. Are you going to the frag swap?
|
#24
|
|||||
|
|||||
![]() Quote:
![]() |
#25
|
|||||
|
|||||
![]() Done and done.
|
#26
|
|||||
|
|||||
![]() Mmmmmm, beer
|
#27
|
||||
|
||||
![]() I would go with more Unions. It will make life a lot easier down the road if u ever want to disassemble the piping for cleaning or if u have something big stuck in there( U never know). I use 5 unions on each pipeline for herbie
|
#28
|
|||||
|
|||||
![]() Quote:
If you're using Loc-line for the return inside the tank (I always do) make sure you buy bulkheads with threads on the inside. You will need a reducer because Loc-line only comes in 1/2" and 3/4". If you can find a SCH80 reducer then it will be grey instead of white, which is nice as it will blend in better with the black Loc-line. If you're using vinyl tubing, I imagine you will be using a 90 degree elbow hose barb fitting with thread on the other end, so you will want your return bulkheads to be thread on both ends. For the drain lines you will want slip (socket) on both ends. You don't have to glue your standpipes in - I prefer not to. Then when cleaning the overflow you can put a sock on the drain and pull the pipes and clean it out real well. They will seal just fine without being glued - double check by filling the overflow with water with the standpipes in and return flow off, mark the water level. Check back in 30 mins and see if the water level went down in the overflow. |
#29
|
|||||
|
|||||
![]() You can also use krylon fusion spray paint to paint the reducer on the locline black. That's what I did. Blends in perfectly.
__________________
Daniel |