|
|
|
#1
03-27-2004, 02:07 AM
|
|||||
|
|||||
Critter/Invert Acrylic Holder
Fin-Omenal Fish (the LFS near my house) was looking for a invert holder that could be hung on the side of the tank, and since I mentioned I've started some acrylic projects, they asked if I could make them one.
I was just going to make a real basic one, but since I had a little time, I went a little... overboard   Instead of putting holes for the waterflow, I went with the design from my tank cover, and put small waves on the front, 2 sides, and the 3 inside walls. The wave slots are 1/16". The 2 hangers are also adjustable in height by 2".  This is a shot without the insides. I made them removable incase they ended up getting a bigger invert, or more of one type, and wanted to keep them in a bigger holding area. And yes, the color is different for the middle wall. I ran out of acrylic, so I used some leftover polycarbonate. Bigger Pictures Here Obviously a picture of it in the tank would help. I'll take one next week. 
|
|
#3
03-30-2004, 02:01 PM
|
||||
|
||||
|
"handy" work
Superb craftsmanship. Did you cnc it or cut it with a saw?
Did you say it was bullet resistant? 
__________________
John its all about quality, not quantity..... ...when in doubt buy a Binford....
|
Linear Mode
