|
|
|
#1
08-25-2011, 04:19 AM
|
|||||
|
|||||
RKL programming help
I'm trying to setup my reef keeper to run a fan when my temp rises too high. I can't get it to work can anyone help?
I programmed a channel like this: Function: controller Device: iTemp Setpoint: 83.0 Hysteresis: 0.1 On when: above 
|
|
#2
08-25-2011, 02:52 PM
|
||||
|
||||
|
mode = auto
function = fan set point = 26.5 celsius or whatever temp you have default = off save Then change the main display to show iTemp by pressing the back button. Did you upgrade to the new firmware?
|
|
#3
08-28-2011, 05:03 AM
|
|||||
|
|||||
|
I don't have function fan, how do I upgrade my firmware?
|
|
#4
08-28-2011, 06:25 AM
|
||||
|
||||
|
go to digital aquatics forum and d/l "Myreef". and hook it up to your PC.
__________________
150DD mix reef with 90 gal sump and 40gal frag tank purple tang, sohal tang, yellow eye kole tang, fairy wrasse. cleaner wrasse, leopard wrasse, and misc fish. GHL Mitras 6200HV X 2, MP40 X 2, MP60 X 1, tunze 6095 X 2, Vertex RX6 calcium reactor, Bubble King SM250, Aquamaxx bio pellets reactor, Profilux 3
|
|
#5
08-28-2011, 06:27 AM
|
|||||
|
|||||
|
You could set up the same way I did my chiller:
Function: Controller Device: iTemp Setpoint: 78.8 (or your desired temp) Hysteresis: 0.2 On when: Above Should kick on at 80 and off at 78.6. And don't forget to set the mode to Auto as mentioned above. I'm still on the older F/W from a year or two back.
|
|
#6
08-29-2011, 06:39 AM
|
|||||
|
|||||
|
How do I connect to a pc? Do I need the net module?
|
|
#9
09-23-2011, 05:23 PM
|
||||
|
||||
|
If you go under Menu --> System --> Units, you can change the temperature to Celsius.
|
Linear Mode
